5-14
Sending Functions
Continuous Scan
When the multi-page originals cannot be placed in the document processor at one time, the originals can be scanned
in separate batches and then sent as one job. With this function, originals can be scanned one after another until you
press [End Scan] (the Right Select key).
The procedure for using continuous scanning when sending scanned images is explained below.
1 Press the Send key.
2 Press the Function Menu key. Function Menu appears.
3 Press the U or V key to select [Continuous Scan].
4 Press the OK key. Continuous Scan appears.
5 Press the U or V key to select [On] and then press the
OK key.
Completed. is displayed and the screen returns to the
basic screen for sending.
6 Specify the destination.
7 Place the original, and press the Start key.
8 Place the next original, and press the Start key. Scan the
remaining originals by the same procedure.
When you have scanned all the originals, press [End
Scan] (the Right Select key) to start sending.
NOTE: Press the Reset key to reset the settings selected in
Function Menu.
To Next Page
Loading...
Need help?
General
