5-18
Sending Functions
5 Press the U or V key to select [From Oper. Panel].
6 Select the destination computer from the computer list.
Press [Detail] (the Right Select key) to see the
information of the selected computer.
7 Press the OK key to confirm the destination, and then
press the Start key. Transmission starts.
NOTE: To change the destination computer, press the Back
key and then press [Yes] (the Left Select key). This brings
you back to step 6.
NOTE: To use WSD Scan from your computer, press [From
Computer] in step 5 and then scan the original from the
computer.
To Next Page
Loading...
Need help?
General
