8-28
Default Setting (System Menu)
Date/Timer
Date/Timer settings include:
• Date/Time …8-28
• Date Format …8-30
• Time Zone …8-31
• Summer Time …8-32
• Auto Error Clear …8-33
• Power Off Rule …8-35
• Power Off Timer …8-37
• Auto Panel Reset …8-39
• Unusable Time …8-41
NOTE: If user login administration is enabled, you can only change the settings by logging in with administrator
privileges.
Date/Time
Set the date and time for the location where you use the machine. If you perform Send as E-mail, the date and time
set here will be displayed on the header.
CAUTION: Be sure to set Time Zone before the Date/Time setup.
Use the procedure below to set the date and time.
1 In the Sys. Menu/Count. menu, press the U or V key to
select [Common Settings].
2 Press the OK key. The Common Settings menu appears.
3 Press the U or V key to select [Date Setting], and press
the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
To Next Page
Loading...
