No. Description Supplement
(40) Life counter (The first line) Machine life/MP tray/Cassette/Paper feeder 1/
Paper feeder 2/Paper feeder 3/Paper feeder 4/Duplex
Life counter (The second line) Bulk Feeder counter/Drum counter K/
Developer counter K/Maintenance kit counter
(41)
Panel lock information F00: OFF
F01: Partial Lock 1
F02: Partial Lock 2
F03: Partial Lock 3
F04: Full Lock
(42) USB information U00: Not installed/U01: Full speed/U02: Hi speed
(43)
Paper handling information 0: Paper source unit select/1: Paper source unit
(44) Auto cassette change 0: OFF/ 1: ON
(45) Black and white printing double
count mode
0: All single counts
3: Folio, Single count, Less than 330 mm (length)
*: The count mode can be changed using a PRE-
SCRIBE command.
When the double count is set for the paper other than
the sizes of A4, B5, A5, Folio, Legal, Letter, and State-
ment, the counter value is indicated as "Other 1" in the
status page. When in the same way, the single count
is set, the counter value is indicated as "Other 2". In
the operation panel, the counter values are indicated
as "Other 1" or "Other 2".
(46) Billing counting timing -
(47) Temperature (machine inside) -
(48) Temperature (machine outside) -
(49) Relative humidity
(machine outside)
-
(50) Absolute humidity
(machine outside)
-
(51) XLI calibration information -
(52) Beam A/BD synchronous fine-
tuning value
-
(53) Beam B/BD synchronous fine-
tuning value
-
(54) Fixed assets number -
(55) Job end judgment time-out time -
(56) Job end detection mode -
(57) PRESCRIBE environmental
reset
-
To Next Page
Loading...
Need help?
General
