Chapter 9: Non-invasive Blood Pressure
Veterinary Vital Signs Monitor Operation Manual 9-7
d)
Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
2. Set High and Low Alarm Limits
The alarm limits displayed in the parameter box are the high and low alarm
limits for SYS and DIA.
Figure 9.4: SYS and DIA Alarm Limits
a)
Push and Turn the rotary knob on the monitor to move the cursor. Highlight
the NIBP parameter box and push the knob to access the NIBP parameter
menu.
b)
Highlight ALARM and push the knob to select.
c)
Choose each pressure value (SYS, DIA, and MAP) and move the cursor to
High/Low and push the knob to select.
d)
Turn the knob to increase or decrease the number and push it to confirm.
e)
Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
3. Choose Alarm Priority
a)
Push and Turn the rotary knob on the monitor to move the cursor. Highlight
the NIBP parameter box and push the knob to access the NIBP parameter
menu.
b)
Highlight ALARM and push the knob to select.
c)
Choose Senior, Junior or Medium and push the knob to select.
d)
Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
9.6.2 Choose the Interval for Automatic NIBP Measurements
If you selected the automatic mode (AUTO) for NIBP measurements (instead
of MANUAL or STAT), the monitor will measure the patient's NIBP periodically,
To Next Page
Loading...
Need help?
General
