Vacon NXP series - Fixing the Cabinet Frames to each Other

vacon • 36 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
4.5 Fixing the cabinet frames to each other
All the necessary parts for fixing the cabinet frames to each other are included in the delivery.
To join two cabinet sections to each other you need six quick-fit baying clamps (1 in figure below)
and four angular baying brackets (2 in figure). The four angular baying brackets are installed in the
top and bottom corners on the inside of the cabinet. Three of the quick-fit baying brackets are
installed in the front and three in the back on the outside of the cabinet.
Figure 18. Quick-fit baying clamps
1
2
1
1
2
1
2
1
1
2
1
2
1
1
2
1
2
13863_00