vacon • 44 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
4.6.6 Auxiliary low-voltage connections
The auxiliary low-voltage connections between cabinets can be done with wiring or with busbars.
For transport, the wires between two separately transported cabinets are disconnected from the
terminals. The wiring diagrams for the connections are delivered with the system drive.
Auxiliary low-voltage busbars (Auxigaine) are available as an option. In this case, the busbars of two
cabinets are connected with quick-connect bridge connectors. The bridge connectors are installed
by simply pressing them into place.
Figure 29. Installing the bridge connectors on the auxiliary low-voltage busbars
To Next Page
Loading...
