Vacon NXP series - Removing the Drives from the Cabinet; Ius_4; Ius_6

vacon • 56 Service
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5.3 Removing the drives from the cabinet
5.3.1 IUS_4 / IUS_6
Servicing is only permitted to be carried out by Danfoss-trained service personnel!
1
Open the cabinet door.
2
Disconnect all cables from the drive. See Chapter 4.6.
3
Release the drive assembly. Remove the four M8x20 bolts (tightening torque 20Nm).
Figure 30. Drive assembly mounting bolts (X) in IUS_4 (left) and IUS_6 (right)
4
Pull out the drive assembly.
Figure 31. Pulling the drive assembly in IUS_4 (left) and IUS_6 (right)
13006.emf
13929_00
X
X
X
X
13930_00