Vacon NXP series - Sections and Options; System Layout and Footprint Drawings; Supplied Documentation

vacon • 8 Introduction
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
1.5.2 Sections and options
Sections and options are selected using the line-up configuration tool.
The available sections and options are introduced in Chapter 3.
1.5.3 System layout and footprint drawings
System layout and footprint drawings are created based on the sections and options selected with
the line-up configuration tool.
1.6 Supplied documentation
Danfoss delivers technical documentation for the switchgear assembled AC drives according to the
Danfoss design standard. The documentation is provided in english.
The scope of supply regarding documentation does not include:
• Special requirements
• Delivery specific requirements
• Customer specific requirements (e.g. marking, naming, coding etc.)
Table 3. Example of selected sections and options from the configuration tool
# Section type Section category Options
1 ADS_600 Control +PES
2 MIS_2500 Incoming power +ICB
3 AFS_13 Incoming power -
4 IUS_4 Outgoing power +ODU
5 IUS_10 Outgoing power +ODU
6 IUS_10 Outgoing power +ODU
7 IUS_12 Outgoing power +ISC, +ODU
8 IUS_7 Outgoing power +ODU
9 IUS_12 Outgoing power +ISC, +ODU
Table 4. Supplied documentation
Document type Electronic format Paper copies
Cable connection table dwg, dxf or pdf 3 sets
Parts list dwg, dxf or pdf 3 sets
Wiring list dwg, dxf or pdf 3 sets
Circuit diagram dwg, dxf or pdf 3 sets
Switchgear layout drawing dwg, dxf or pdf 3 sets
Device layout drawing dwg, dxf or pdf 3 sets
VACON
®
manuals (as applicable)
pdf 3 sets