Adapting the unit to the heating installation
ecoTEC plus installation and maintenance instructions 0020134823_01 39
12
12 Adapting the unit to the heating
installation
The installation assistant is started when the boiler is
switched on for the first time (¬section11.2).
If you have already filled the heating installation and termi-
nated the installation assistant, but wish to set the most
important system parameters again, you can also call up
the "Appliance configuration" menu point.
Menu ¬ Installer level ¬ Appliance configuration
All of the settings for more complex systems can be found
in the diagnostics menu.
Menu ¬ Installer level ¬ Diagnostics menu
12.1 Overview of the parameters in the
diagnostics menu
Menu ¬ Installer level ¬ Diagnostics menu
You can use the parameters that are marked as adjustable
in ¬table12.1 to adapt the boiler to the heating installation
and the needs of the customer:
i
You can enter your settings in the last column
after setting the system-specific parameters.
> Press the minus button
or the plus button
to switch between the displayed diagnostics
codes.
For modifiable parameters:
> Press the right-hand selection button
("Select") to select the parameters to be changed.
> Press the minus button
or the plus button
to change the current setting.
> Press the right-hand selection button
("OK")
to confirm the change.
The change is saved.
To Next Page
Loading...
