Figure 6 Attaching DIN rail clip fasteners
1. Open the 2 hex screws on the cover of the transmitter using a 4-mm hex key.
2. Open the transmitter cover.
3. Attach the DIN rail clip fasteners on the back of the transmitter using 2 × 14-mm screws
and a 5-mm hex key. Place nylon washers under the screws to protect the surface of the
transmitter.
4. Mount the transmitter on the DIN rail.
3.2.4 Pole mounting
• Hex keys (4 mm and 5 mm), provided
• Screws 14 mm (2 pcs), provided
• Washers (2 pcs), provided
• Installation kit for pole or
pipeline (item code 215108):
• Fixing brackets (2 pcs) for
100 mm poles
• Mounting nuts for fixing
brackets, M8 (4 pcs)
• Mounting plate (1 pcs)
Using fixing brackets and a mounting plate, you can install the transmitter to a vertical or
horizontal pole.
Chapter 3 – Installation
21
To Next Page
Loading...
