Vaisala Indigo 500 Series - Creating Web Interface Users; Figure 18 User Creation Page

5. Open a web browser. In the address field, type https://<transmitter's IP
address>:8443.
• Example: https://172.24.65.229:8443
You can see the IP address of the transmitter on the touchscreen, at the
bottom left corner of the configuration menu .
Your web browser may give a certificate error, but you can safely proceed to the
transmitter's IP address. You are next prompted to log in or create users.
5.2.2 Creating web interface users
Hex key (4 mm) for opening the transmitter cover
When you connect to the web interface for the first time, or when you start using the
transmitter after a factory reset, you are prompted to create users for the web interface.
Figure 18 User creation page
The web interface has 2 user levels:
• Administrator: Configuration rights. Can configure outputs and change transmitter
settings.
• Guest: View-only access. Can add and remove measurement parameters in the
Measurements view.
1. In the User creation page, select Continue.
Indigo 520 User Guide M212287EN-A
40