The MiniCT sensor cannot currently be enabled via the on screen menus. The instrument must be
interrupted (See section 9) and the following commands used to enable/disable. A miniCT set up
menu will be available once the sensor is enabled.
#075 Reads back current miniCT status (0 – disabled, 1 – Enabled)
#074;0 Disables miniCT sensor
#074;1 Enables miniCT sensor
6.2.2 Sampling Set Up
The sampling set up of the instrument can be configured in this menu. Default burst modes can be selected
or a custom sampling mode can be user defined.
• Sampling
➢ Burst
- B1 - 30s/1 min
- B2 - 40s/6 min
- B3 - 40s/10min
- B4 - 40s/15min
- B5 - 60s/30min
➢ Continous
- M1 - 1Hz
➢ Custom
- Burst Interval Mins
• Enter Value
- Burst Duration Secs
• Enter Value
6.2.3 Logging Set Up
Date/Time can be configured in this menu, and any existing data files erased from the unit.
• Logging
➢ Set Time/Date
- DD/MM/YYYY HH:MM:SS
➢ Clear Memory
- Yes
- No
To Next Page
Loading...
