SECTION
2
Force 2 User’s Guide 2-1
2Installation
This section describes how to install the Force 2 Generator.
Inspect the Generator
Inspect the generator for any signs of physical damage to the control
panel, base assembly and cover. Perform functional tests as specified in
the “Testing and Calibration” Section of the service manual. If physical
damage is found or the electrosurgical generator does not perform within
specifications, file a claim with the carrier. All returns must have approval
from Valleylab.
Responsibility of the Manufacturer
Valleylab is responsible for safety, reliability, and performance of the
equipment only if:
• installation procedures in this manual are followed
• assembly operations, extensions, re-adjustments, modifications or
repairs are carried out by persons authorized by Valleylab
• electrical installation of the relevant room complies with local codes
and regulatory requirements such as IEC and BSI
• equipment is used in accordance with the Valleylab instructions for use
To Next Page
Loading...
