Valleylab Force 2 - Front Panel Controls

Controls
Description of Controls, Indicators,
and Receptacles
Force 2 User’s Guide 3-3
Controls
Standby – Press this button to place the electrosurgical generator in a hold
mode. The generator cannot be activated and all audio alarms are
silenced. Power settings are retained in memory and the display shows
dashes.
Ready – Press this button to place the generator into service with power
outputs, displays, and alarms fully functional.
PCH Monopolar – Press this button to select the monopolar footswitch control
for activating the Accessory receptacle.
Bipolar – Press this button to select the bipolar output when using the
monopolar footswitch.
Power Up – Increases power in the selected mode. A single press of the
button increases the power setting by one watt. Continuously pressing
the button gradually increases the power to maximum.
Power Down – Decreases power in the selected mode. A single press of the
button lowers the power setting by one watt. Continuously pressing the
button gradually decreases the power to minimum.
Pure Cut – Press this button to select cut with the lowest level of hemostasis.
Blend 1 – Press this button to select cut with minimum hemostasis.
Blend 2 – Press this button to select cut with moderate hemostasis.
Blend 3 – Press this button to select cut with maximum hemostasis.