Need help?Do you have a question about the Valleylab Force 2-2 PCH and is the answer not in the manual?
Procedure for safely removing the generator from its packaging.
Details on manufacturer's responsibilities for safety, reliability, and performance.
Guidelines for placing and positioning the electrosurgical generator.
Specifications for the nominal operating voltage and frequency.
Ensuring the proper hospital-grade power cord is used and maintained.
Steps to guarantee patient safety through correct electrical grounding.
Instructions for conducting a pre-use system check of the generator.
Description of the generator's front panel buttons and their functions.
Explanation of the various status and mode indicators on the generator.
Details on the generator's alarm system and indicators.
Identification and function of the generator's input and output connectors.
Description of controls and connectors located on the rear of the unit.
Conditions under which technical specifications are measured.
Environmental limits for generator operation.
Environmental limits for generator storage and transit.
Characteristics of the electrical waveforms generated by the device.
Power output data across different loads and modes.
Voltage and current requirements for the generator.
How output power varies with input voltage fluctuations.
Specifications related to RF leakage currents.
Specifications for 50-60 Hz leakage currents.
Details on the patient return electrode monitoring system.
Device classification according to safety standards like IEC 601-1.
Graphical representation of output power versus load impedance.
Description of the bipolar output power display circuitry.
Description of the main control and user interface board.
Explanation of how mode indicators are driven.
Circuitry for REM and RMOTE status indicators.
Description of the RF output status indicators.
Details on the external memory locations used by the system.
Description of the interface board functions and connections.
Description of the generator's DC power supply circuitry.
Description of the RF output amplification and control circuitry.
Recommended schedule and checks for generator upkeep.
Guidelines for safely cleaning the generator and its components.
Important precautions and considerations for performing tests.
List of necessary equipment for calibration and testing.
Procedure for the generator's initial power-on diagnostic test.
Steps for calibrating the generator's output and parameters.
Procedure for testing the REM Contact Quality Monitoring system.
Procedures for measuring RF leakage in bipolar and monopolar modes.
Information required and steps for returning the generator for service.
Guidelines for packaging the generator for shipment.
Guidelines for packaging internal components for return.
Information needed when ordering parts from Valleylab.
List of components for the Monopolar Control/Display board.
List of components for the Bipolar Display board.
List of components for the Interface board.
List of components for the Power Supply RF board.
List of components for the Heatsink Assembly.
List of components for the Generator Base Assembly.
General| Type | Electrosurgical Generator |
|---|---|
| Cut Modes | Pure Cut, Blend 1, Blend 2, Blend 3 |
| Power Settings | Adjustable |
| Output Waveforms | Cut, Coagulation |
| Coagulation Modes | Fulguration |
| Activation | Handswitch or Footswitch |
| Power Requirements | 50/60Hz |
| Output Power | 300 watts |
To Next Page
