12. FITTING THE FASCIA
12.1 Assembling the ‘Opulent’ fascia
(See figure 28).
Step 1. Lay the fascia face
down on a flat surface.
Step 2. Unscrew and remove
the side infill panel. Discard the
side infill panel and screws.
Step 3. Locate the slider
control and secure through the
upper hole with 1 off
countersunk M4 x 10mm screw
supplied.
Step 4. Secure the bottom of
the slider control using 1 off
countersunk M4 x 10mm screw
supplied.
Step 5. Supplied with the fire is
a self adhesive control position
label. Peel the backing from
the label and position as in
figure 29.
Page 32
© Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
Figure 29. Control position label
Figure 28. Opulent fascia
To Next Page
Loading...
