CONTENTS (Continued)
Section Heading Page
11. CERAMIC WALLS INSTALLATION 31
12. FITTING THE FASCIA 32
12.1 Assembling the ‘Opulent’ fascia 32
12.2 Assembling the slider control to the ‘Heritage’ fascia. 33
12.3 Fitting the fascia to the hotbox. 33
13. FITTING THE CERAMIC FUEL EFFECT 34
14. FRONT / CASTINGS INSTALLATION 35
15. FULL OPERATING CHECKS 35
15.1 Check the Control Settings 35
15.2 Check for spillage 36
15.3 Flame supervision and spillage monitoring system. 37
16. FINAL REVIEW 38
17. SERVICING & PARTS REPLACEMENT 39
17.1 Checking the aeration setting of the burner. 40
17.2 To remove the ignition microswitch. 40
17.3 To remove the gas shut-off microswitch. 40
17.4 To remove the fascia. 41
17.5 To replace the control slide unit. 42
17.6 To replace the control slide button. 42
17.7 To remove the burner unit. 42
17.8 To remove the electronic ignition generator. 43
17.9 To remove the thermocouple interrupter block. 43
17.10 To remove the pilot unit. 44
17.11 To remove the shut-off tap. 44
17.12 To remove the gas flow rate controller. 45
17.13 To replace the burner. 45
17.14 To remove the main burner injector. 46
17.15 To remove the appliance from the fireplace. 46
Page 6
© Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
To Next Page
Loading...
