10
Installer - READ THIS FIRST!
1. YOU NEED TO KNOW FROM THE HOMEOWNER:
• What accessories (surround, screen, fan*, etc)
will be installed
2. Unpack the appliance, removing all items packed
inside and around it. Recycle the packaging.
3. Check that you have everything, using the Pack Con-
tent sheet. Also, check that you have:
• Fuel bed (packed separately)
• Liner panels (packed separately)
• Optional accessories (if ordered)
• Gas conversion kit (if necessary)
• Venting accessories
• Electrical accessories (if used)
4. Carefully read the Installer’s Checklist included with
the fi replace for the installation sequence.
Caution
Only qualified, licensed, or trained personnel
should install this appliance.
Note
* If installing a fan, you will need to use the remote
control to test the fan operation. In this case, put
batteries in the handset and the battery holder and
set up the remote control.
Electrical connections must be done BEFORE
the appliance is placed in its fi nal position, since
the connections are done from the back of the
appliance.
Installation Planning
Before Installation
To Next Page
Loading...
Need help?
General
