23
Installation
Fuel Beds
Install Traditional Log Kit 700LSK
Material required
• Traditional Log Kit, which contains:
• 10 logs
• 1 bag of embers
• Gloves, if desired
Installation
Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have pegs
to help you place them on the burner platform, or other
logs.
Install the logs as shown below.
1. Confi
rm the front edge of the rear log support is
fl ush with the cutout in the burner support
platform.
G7
G8
G9
G16
H28
G10
H31
G4
H10 H11
1
1
11
2. Place log G4 directly on the burner, and slide it all
the way to the left. There is a groove on the
underside of the log that fi ts on the front rail on the
burner.
3. Place log H10 in the front left cutout in the burner
platform with its long end pointed to the left.
4. Place log H11 in the front right cutout in the burner
platform. Orient the H11 with its angled end
pointing to the right.
G4
H11
H10
G4
Angled
end
G4
H10
longer on
left side
To Next Page
Loading...
Need help?
General
