20
Installation
Fuel Beds
Install Birch Log Kit 700BLK
Material required
• Birch Log Kit, which contains:
• 10 logs
• 1 bag of embers
• Gloves, if desired
Installation
Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have pegs
to help you place them on the burner platform, or other
logs.
Install the logs as shown below.
1. Confi
rm the front edge of the rear log support is
fl ush with the cutout in the burner support
platform.
2. Place log G4 directly on the burner, and slide it all
the way to the left. There is a groove on the
underside of the log that fi ts on the front rail on the
burner.
3. Place log H10 in the front left cutout in the burner
platform with the long end pointing to the left.
4. Place log H11 in the front right cutout in the burner
platform. Orient the H11 with its angled end
pointing to the right.
G4
H11
H10
G4
Angled
end
G1 G2
G3
H7
H11H10
G6
G5
H9
G4
G4
H10
longer on
left side
To Next Page
Loading...
Need help?
General
