5
• ALWAYS disconnect this unit from the power supply before
performing any assembly or cleaning, or before relocating the
electric replace.
• NEVER leave this heater unattended. ALWAYS unplug this
heater when not in use.
• ALWAYS store this heater in a dry location. NEVER use the
replace if it has become wet.
• ONLY use this heater on a 120V AC 15-Amp or 240V AC
15-Amp circuit. NEVER overload the circuit. If this heater trips
the circuit breaker, unplug all other appliances on the same
circuit before the next use. Avoid plugging other appliances
into the same circuit as this heater.
• NEVER plug this heater into an outlet that is old, cracked, or
has any loose wires or connections. Plugging this heater into
a faulty outlet could result in electric arcing within the outlet
that could cause the outlet to overheat or catch re.
• ALWAYS check your heater cord and plug connections with
each use!
• MAKE SURE the plug ts tight in the outlet! Faulty wall outlet
connections or loose plugs can cause the outlet to overheat.
• Heaters draw more current than small appliances. Overheating
may occur even if it has not occurred with the use of other
appliances.
• During use check frequently to see if the plug outlet or
faceplate is HOT! If the outlet or faceplate is HOT, discontinue
use immediately and have a qualied electrician inspect and/
or replace the faulty outlets.
SAVE THESE INSTRUCTIONS!
To Next Page
Loading...
