4.7.2.2 Checking the coolant level
Check the coolant level periodically.
NOTE: Drain the cooling system completely every second year and refill it with
new coolant.
GUID-2D58F4D7-629A-44D2-A729-D0B28A3C1232
1. Cap of the coolant expansion tank
2. Cold fluid level mark
1. Stop the engine and let it stand for a few minutes.
The checking must be made when the fluid is cold. A hot fluid level is higher
than a cold.
2. Check that the fluid level in the expansion tank is in accordance with the fluid
level mark for cold fluid.
3. Add more coolant to the tank, if necessary.
IMPORTANT: Never use only water as coolant.
• Check the freezing point of the coolant.
At the beginning of the cold season it is important to measure the
freezing point.
• If the freezing point is too high, drain off some of the coolant and top up
with antifreeze.
• Run the engine for a while.
The antifreeze must be mixed with the coolant.
• Re-check the freezing point of the coolant.
4. Maintenance
- 269 -
To Next Page
Loading...
Need help?
General
