VAMP 135 - 4 Operating Measures; Measured Data

VAMP 135 Over-, under-, residual voltage and
frequency relay
Operation and configuration
VAMP Ltd
14
VAMP 24h support phone : +358 (0)20 753 3264 VM135.EN008
4. Operating measures
General
Carefully study the operating instructions in Chapters 1
through 3 of this manual before any operating measures are
taken or before any relay settings or functions are changed.
The relay can be controlled by means of the MMI on the relay
front panel, a PC running the VAMPSET software, a PC
running suitable terminal software or a remote control system.
4.1. Measured data
The measured values can be read from the main menu
MEASURES and its submenus shown in the figure below.
MEASURES U12:10950V
U23:10960V
U31:10950V
UL1:6320V
UL2:6330V
UL3:6320V
U0:0.0%
f=50.2Hz
measuremode.eps
U0:0V
Figure 4.1-1. Measures menu of the VAMP 135 relay.