VAMP 135 - 5 Configuration and Parameter Setting

VAMP Ltd
Over-, under-, residual voltage and
frequency relay
Operation and configuration
VAMP 135
VM135.EN008 VAMP 24h support phone : +358 (0)20 753 3264
19
5. Configuration and parameter
setting
User level: CONFIGURATOR
• Choose the protection functions in the ENABLE position of
the main menu, see chapter 5.2.
NOTE!
Protection functions not enabled will not be shown in the
submenus.
• Change the parameters of over- and undervoltage
protection functions in the U SETTING position of the main
menu, see chapter 5.3.
• Change the parameters of residual voltage protection
functions in the Uo SETTING position of the main menu,
see chapter 5.3.
Note!
The U
0
protection functions are available only if U
mode
:
Line+ U
0
or Phase is selected. See Chapter 2.2. of Technical
description.
• Change the parameters of frequency protection functions in
the f SETTING position of the main menu, see chapter 5.3.
• Change the parameters of Circuit Breaker Failure
Protection function in the CBFP Set position of the main
menu, see chapter 5.3.
• Set the voltage scaling (e.g. U
prim
, U
sec
, U
mode
, etc.) in the
SCALING position of the main menu, see chapter 5.4.
• Set the residual voltage scaling (U
0sec
) in the U
0
SCALING
position of the main menu, see chapter 5.4.
• Configure the digital outputs in the DOUT position of the
main menu, see chapter 5.5.
• Configure the interlockings in the BLOCKING position of
the main menu, see chapter 5.6.
• Configure the digital input in the DIGITAL IN position of
the main menu, see chapter 5.7.
• Choose and configure the communication buses in the COM
position of the main menu, see chapter 5.8.
• Configure the analog output in the mA OUTPUT position of
the main menu, see chapter 5.9.
• Set the Date and time in the SERVICE position of the main
menu, see chapter 5.11.