Vatech PaX-Primo - Default Chapter; Table of Contents

Installation manual
1
Contents
Chapter 1. Introduction ...................................................................................................................... 5
1.1. Product features .................................................................................................................. 5
1.2. The product appearance and description: wall-mounted type ............................................. 7
1.3. Exposure switch ................................................................................................................... 8
1.4. Replacement parts and positioning accessories ................................................................. 9
1.5. PaX-Primo’s general specification ..................................................................................... 10
1.6. X-ray generator .................................................................................................................. 11
1.7. X-ray tube(Toshiba D-051) ................................................................................................. 11
1.8. Collimator ........................................................................................................................... 11
1.9. Environmental characteristics ............................................................................................ 12
1.10. Dimension of the Unit ..................................................................................................... 13
1.11. Focal spot distance ........................................................................................................ 14
1.12. X-Ray generator technical specifications ....................................................................... 15
1.12.1. X-Ray Tube Specification........................................................................................... 15
1.12.2. High voltage generator .............................................................................................. 16
1.12.3. X-Ray generation controller ....................................................................................... 16
1.12.4. Beam limiter ............................................................................................................... 16
1.13. System Characteristics .................................................................................................. 17
1.13.1. Mechanical Characteristics ........................................................................................ 17
1.13.2. Electrical Characteristics ........................................................................................... 17
1.13.3. Environmental Characteristics ................................................................................... 17
Chapter 2. Preparing for installation ................................................................................................ 18
2.1. Checking packing list ......................................................................................................... 18
2.1.1. Location of the parts and assembly units supplied .................................................... 18
2.1.2. Parts list ..................................................................................................................... 19
2.2. Tools required .................................................................................................................... 20
2.3. Standard Accessories ........................................................................................................ 21
2.4. Check Shock Watch and Tilt Watch .................................................................................. 21
Chapter 3. Installing the equipment ................................................................................................. 22
3.1. Assembling the wall mount ................................................................................................ 22
3.2. Assembling the base (optional) ......................................................................................... 37
3.3. Installing the touch pad screen on the wall (optional) ........................................................ 40
3.4. Installing exposure switch holder ....................................................................................... 46
3.5. Exiting packing mode and finishing installation ................................................................. 51
Chapter 4. Installing and removing Imaging software ...................................................................... 52