9,
DESCRIPTION OF THE UNIT CONTROLS.
Each unit has a pushbutton panel for coffee dispensing.
1 Continuous dispensing/programming button “ ”.
• Press the button (1) to start continuous coffee dispensing; to stop dispensing,
press the button again.
• Pressing and holding this button for 10 seconds, you access dose programming
(see the paragraph “PROGRAMMING THE DOSES”).
2 “One short coffee” dispensing button “ ”.
• Press the button (2) to start coffee dispensing; when the programmed
amount has been reached, dispensing will automatically stop.
3 “One long coffee” dispensing button “ ”.
• Press the button (3) to start coffee dispensing; when the programmed
amount has been reached, dispensing will automatically stop.
4 “Two short coffees” dispensing button “ ”.
• Press the button (4) to start coffee dispensing; when the programmed
amount has been reached, dispensing will automatically stop.
5 “Two long coffees” dispensing button “ ”.
• Press the button (5) to start coffee dispensing; when the programmed
amount has been reached, dispensing will automatically stop.
6 Hot water dispensing button “ ”.
• Press the button (6) to start hot water dispensing; when the desired amount
has been reached, press the button (6) again to stop dispensing.
7 Manual coffee dispensing switch.
• In the event of an electronic card fault, coffee can manually be dispensed;
press the switch (7) to start dispensing and when the desired amount has
been reached, press the switch (7) again to stop dispensing.
Manuale_Replica2B Elettronica_Rev0_5lingue_03-2016.indd 24 19/04/16 17:28
To Next Page
Loading...
