12.4,
DISPENSING STEAM.
• Turn the steam nozzle (1) towards the drip tray and dispense briefly into the
tray by turning the tap (2) anticlockwise in order to remove any residual water
present in the circuit.
The nozzle (1) is very hot.
Only move the nozzle gripping it by its rubber protection (3) as there
is a risk of scalding yourself.
• Move the steam nozzle (1) to the outside and then put a cup or a jug full of
liquid to be heated underneath the nozzle (1).
• Fully immerse the spout of the steam nozzle into the liquid and slowly open the
tap (2) by turning it anticlockwise.
• Once the desired temperature has been reached, close the tap (2) by turning it
clockwise.
• Turn the steam nozzle (1) towards the drip tray and dispense briefly into the tray
to clean the inside of the nozzle and then clean the outside with a moist cloth
to prevent encrustations difficult to remove.
Manuale_Replica2B Elettronica_Rev0_5lingue_03-2016.indd 38 19/04/16 17:28
To Next Page
Loading...
