7 Component Removal Removing The AC Input Filter And Power Supply Board
7-6
Figure 7-8. Remove AC Channel Cover
4. Remove the three T15 screws in the AC Input Filter (item 1 in Figure 7-9).
5. Lift the Power Supply shield up to disengage the two retention snap pins in its right side flange and remove it
from the console (item 2 in Figure 7-11).
6. Grasp the AC Input Filter handle (see item 3 in Figure 7-9) and slowly pull up and away from the Power Supply
board until the two AC Input Filter plugs disconnect from the Power Supply board connectors. Lift the AC Input
Filter out of the console. Remove the two T-15 screws that secure the AC Input board to the AC input board
bracket. Place fingers under the AC Input board near each of the two retention pins and lift the board up until it
is free of the pins.
To replace the AC Input Filter reverse the above steps. To remove the Power Supply Board continue to Step 7.
Legend For Figure 7-8
Item Description Item Description
1 AC Channel cover. 2 T15 screws (2).
To Next Page
Loading...
