1-1
1 Introduction
This manual contains troubleshooting information for the TLS-450PLUS console. Most of the components dis-
cussed in this manual are to be replaced if faulty. The intent of this manual is to help you identify replaceable parts
and assemblies and to provide accepted troubleshooting methods where applicable. Information on individual plug-
in modules is covered in manuals accompanying those components and/or systems.
Related Manuals
Troubleshooting of a TLS-450PLUS console requires knowledge of the system site prep and installation as well as
setup and operation of all installed options. Refer to the Tech Docs CD-ROM (V-R P/N 331650-001) for all
relevant manuals:
577013-934 TLS-450 & TLS-450PLUS Consoles Site Prep Certification Manual
577013-950 TLS-450/TLS-450PLUS/TLS4 Console Serial Interface Manual
577014-048 TLS-450 to TLS-450PLUS Console Upgrade Instructions
577014-072 TLS-450PLUS Operator's Quick Help
577014-073 TLS-450PLUS Console Site Prep And Installation Manual
577014-074 TLS-350 to TLS-450PLUS Console Upgrade Instructions
577014-075 TLS-450PLUS Console Troubleshooting Guide
577014-076 TLS-450PLUS Console Board and Software Replacement/Upgrade Manual
577014-077 TLS-450PLUS Console Module Replacement Instructions
577014-078 TLS-450PLUS Console Hardware Replacement Guide
577013-344 PLLD Troubleshooting Manual
577013-401 TLS Consoles Point-of-Sale (POS) Application Guide
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Installer Certification (Level 1): Contractors holding valid Installer Certification are approved to perform wiring
and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless
equipment installation; tank and line preparation; and line leak detector installation.
Technician Certification (Level 2/3): Contractors holding valid Technician Certifications are approved to
perform installation checkout, startup, programming and operations training, system tests, troubleshooting and
servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. In addition,
Contractors with the following sub-certification designations are approved to perform installation checkout, startup,
programming, system tests, troubleshooting, service techniques and operations training on the designated system.
•Wireless 2
• Tall Tank
VR Vapor Products Certification: Contractors holding a certification with the following designations are
approved to perform installation checkout, startup, programming, system tests, troubleshooting, service techniques
and operations training on the designated system.
• ISD – In Station Diagnostics
• PMC – Pressure Management Control
• CCVP - Veeder-Root Vapor Polisher
To Next Page
Loading...
