Vega FIBERTRAC 31 - Page 41

41
6 Set up with the display and adjustment module
FIBERTRAC 31 • Probus PA
43833-EN-170126
Pulse rate of the sensor
Process value
Switching function of the relay
Information:
10 minutes after the key was pressed for the last time, the simulation
is interrupted automatically. You can also interrupt the simulation with
the switch on the electronics module.
Additional settings
In this menu item you can set the actual date, time and display format.
When a reset is carried out, all settings (with only a few exceptions)
are reset. The exceptions are: PIN, language and SIL.
The following reset functions are available:
Basic settings: Resetting of the parameter adjustments to default
values at the time of shipment. Order-specic settings are deleted.
Default settings: Resetting of the parameter adjustment like under
"Basic settings". In addition, special parameters are reset to default
values. Order-specic settings are deleted.
Additional settings - Date/
Time
Additional settings -
Reset