VELUX 9
Menu
Locate
Register Back
P1
P2
P1
P2
5
Press "Register" to start registration.
6
Registration is running. This can take up to two minutes.
7
The display shows "Completed" when all products have
been registered.
Note: If the display shows "Failed", remove the batteries
from the remote control. Prepare the products for registra-
tion, see section Resetting and preparing for registration.
Repeat the initial set-up.
8
The display shows one of the registered products.
Press
to see the other registered products.
For use of more than one remote control, all products must
be registered in one of the remote controls, see above.
Then the information must be copied from this remote
control to the other remote controls, see section Using
additional activation controls.
Note: The opening of the skylight operator must be
adjusted if your skylight is positioned within reach, see
section Adjusting the maximum opening.
To Next Page
Loading...
Need help?
General
