VEMAG HP30E - 1.5 Special safety instructions

HP25E / HP30E1. Safety instructions
1-4 © VEMAG 2018
1.5 Special safety instructions
Danger!
To prevent injury, switch o󰀨 the machine before any work (assembly, dis-
mantling, cleaning, maintenance, repair). Then switch o󰀨 the main switch
to disconnect the machine from the mains.
Danger!
To prevent injury in the area of the double screws, switch o󰀨 the machi-
ne before undoing the locking nut. Then switch o󰀨 the main switch to
disconnect the machine from the mains. The lling horn holder, grinder
(optional) or linking gear (optional) may only be tted or removed with the
machine switched o󰀨.
Before starting up the machine, always perform the following steps:
• Check that the machine is in proper condition. Leaking oil indicates
leaks which must be eliminated immediately. In this case, inform your
in-house maintenance department or VEMAG Customer Service
immediately.
• Check that the safety devices on the hopper and lling horn holder are
working properly.
Section 5
If you notice any damage, inform VEMAG Customer Service immedi-
ately.
Danger!
To prevent injury, switch o󰀨 the machine before doing any work on the
hopper. Then switch o󰀨 the main switch to disconnect the machine from
the mains. Do not climb onto the machine to check the hopper/hopper
contents, use only the step provided. Under no circumstances use a lad-
der or other aid to get at the hopper of the machine.
Danger!
No-one may stand in the area of the lifting/tipping device (optional). Do
not put any objects in this area.
Only trolleys to DIN 9797 with a capacity of 200 l or 300 l (optional) are
permitted.
200 l: Max. total weight incl. trolley 240 kg
300 l: Max. total weight incl. trolley 350 kg