VEMAG HP30E - 5. Operation; 5.1 Working with the machine

HP25E / HP30E 5. Operation
5-1© VEMAG 2018
5. Operation
5.1 Working with the machine
To start production with the machine, proceed as follows:
• Set up the machine for the product to be lled.
Section 4
• Switch on the main switch of the machine.
• Press the ON switch on the machine control panel.
Danger!
You must check that any safety devices are working properly.
• Unlock the hopper and tip it open.
• Remove the lling horn holder.
In each of the cases described, the machine must switch o󰀨 automati-
cally. If the machine does not switch o󰀨, work may not continue with the
machine. In this case, inform VEMAG Customer Service immediately.
• Pull on a casing suitable for the product to be lled.
• Push the trolley containing product into the trolley hoist of the lifting/
tipping device up to the stop. The locking lever must lock and hold the
trolley securely in the trolley hoist.
• Press the UP key of the lifting/tipping device to move the trolley over
the hopper with the trolley hoist. The trolley is automatically emptied
into the hopper.
Danger!
Make sure that there is no-one in the area of the lifting/tipping device
during operation and that no objects have been deposited there.
Insert only undamaged trolleys that will be securely held by the trolley
hoist.
• Press the DOWN key to lower the trolley again. The trolley hoist stays
approx. 500 mm above the oor. Press the DOWN key again and
keep it depressed until the trolley has reached the oor.