These setup steps allow the user to monitor FAN runtimes and program
service alerts. Service alerts appear on the display. If the thermostat is joined
to a Skyport account, then the user may be alerted by Skyport Cloud Services
when to change the filter.
Runtime hours
or days appear in
the clock display.
Press and hold FAN
to clear reset runtime.
Service Filter Runtime (Setup Steps 7-10)
Current Service Filter Runtime Hours (Setup Step 7)
- This counter keeps track of the number of hours of
fan runtime in the Heating mode, Cooling mode, and
in stand alone Fan operation.
Press FAN to reset.
Current Service Filter Calendar Days (Setup Step 8)
- This counter displays the total number of calendar
days that have elapsed since the counter was reset
to help the user track Fan runtime.
Press FAN to reset.
Set Service Filter Runtime Hours (Setup Step 9) -
This timer allows the user to specify the number
of hours the fan will run before the “Replace Filter”
alert will be displayed. Press COOLER continuously
until OFF is displayed to disable this alert.
Set Service Filter Calendar Days (Setup Step 10) -
This timer allows the user to specify the number of
calendar days that will elapse before the “Replace
Filter” alert will be displayed. Press COOLER
continuously until OFF is displayed to disable
this feature.
User Setup: Service Filter
19
FAN
To Next Page
Loading...
