SETUP
Cable Connections
16 P400/P400 PLUS INSTALLATION GUIDE
• Multi-media function (video playback or audio function) has to be switched off
by user or customer app when CTLS payment mode is activated. Other
modes of payment like smart card and MSR payment can be supported.
Cable
Connections
The P400 has several cabling scenarios, depending on what it connects to:
1 Connection to Another Verifone Terminal.
2 RS-232 Connection Using an External Power Brick.
3 Direct USB Connection.
4 Powered USB Connection.
5 Ethernet Connection with External Power Brick.
Attaching a Cable
Connector to the
P400
Before going into each cabling scenario, the cables first have to be attached to the
P400. To attach a cable to the terminal, follow steps 1-2 in the
Installing or
Changing MSAM/uSD Card section to open the compartment door, then attach
the 28-pin connector of the cable to the terminal.
Figure 4 Using the 28-Pin Connector
Connection to
Another Verifone
Terminal
The P400 can be powered by another Verifone terminal in two ways:
• Serial Connection
• USB Connection
CTLS payment mode is defined as the state of the device where RF transmission
is broadcasting to allow for a CTLS payment. This is activated either during the
scanning of items or at the completion of scanning items during the checkout
process, depending on how the application sets it up. As soon as checkout is
complete, the device exits CTLS payment mode and remains off until activated for
the next checkout.
Turn off or unplug the terminal when connecting or disconnecting the device to
avoid device memory corruption and data loss.
Refer to the controlling device instructions for any terminal-specific warnings.
To Next Page
Loading...
Need help?
General
