DEVICE SETUP
Examining e355 Device Features
E355 INSTALLATION GUIDE 17
7 Place the battery cover back and tighten the screw.
Figure 6 Returning the Battery Cover
Manually Starting
and Resetting the
e355
To turn on the e355, press and hold the Enter key for at least five seconds.
The Reset button is located between the right Barcode Button and Power LED
Indicator.
Connecting the e355
to a Power Source
or a Host Computer
Plug the wall-mount charger to an external power source and connect it to the
e355 to charge the device. You can also connect the e355 to a computer to
synchronize data and/or charge the device.
To Connect the e355
to a Wall-mount
Charger
1 Plug the Verifone-certified wall-mount charger into a wall outlet or powered
surge protector.
2 Insert the Micro-USB cable into the port located on the side of the e355.
Figure 7 Connecting the e355 to a Wall-mount Charger
The Reset button resets the device to its initialized state. NEVER use the Reset
button unless instructed by a Verifone support representative.
Charge the e355 device for eight hours before initial use.
To Next Page
Loading...
Need help?
General
