DEVICE SETUP
Charging the Battery
22 V660P INSTALLATION GUIDE
To install a paper roll 1 Hold both sides of the paper door, which is on the upper corner of the device
and open the paper door by pulling outside (See below Figure 9).
2 Remove any partial roll of paper in the tray.
Figure 10 Steps to Install a Paper Roll in the V660p-1
3 Loosen the glued leading edge of the new paper roll or remove the protective
strip. Unwind the paper roll past any glue residue.
4 Hold the roll so that paper feeds from the bottom of the roll.
5 Pull the paper past the printer door.
6 Align the printer paper to the tabs to the paper guides and hold the paper up
when closing the door.
7 With the printer paper extending outside, close the printer door by swinging
upward until the door clicks shut, allowing the printer paper to extend outside
the printer door.
Charging the
Battery
After unpacking your V660p-1 devices, connect the power pack to the unit for
eight hours or until fully charged. Refer to the Using the Battery section for more
details.
Battery Life
Charging and discharging the battery will cause normal wear on the battery.
Li-Polymer and Li-Ion batteries must be recycled or disposed of
properly as per local guidelines/regulations.
To Next Page
Loading...
Need help?
General
