EasyManuals Logo

VeriFone Vx520 User Manual

VeriFone Vx520
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Page
4 (37)
POINT TRANSACTION SYSTEMS OY
Vanha Nurmijärventie 62 FI-01670 VANTAA | tel: +358 (0)9 477 4330 | fax: +358 (0)9 436 2490
www.point.fi
1. BEFORE USE
1.1 Important
NOTE! If these instructions are not followed and the terminal is damaged it will void the
warranty!
Protect the power cord and modem. If they are damaged they are not to be used anymore.
The terminal is not waterproof or dustproof, and is intended for indoor use only.
The warranty of the terminal will void if it is exposed to water or dust.
Do not use the terminal next to water or moist areas.
Do not use belowC degrees.
Never place anything inside the chip slot or connection ports that are not meant there. This
might seriously damage the terminal.
If the terminal is damaged contact Point’s maintenance service. Never try to fix the terminal
by yourself.
Use only appropriate paper with the terminal’s printer. Poor quality paper can jam the
printer and create excessive paper dust.
Never use thinner, trichloroethylene, or ketone-based solvents- they may cause
deterioration of plastic or rubber parts. Do not spray cleaners or other solutions directly onto
the keypad.
Always shut down the terminal before removing the battery.
Disconnecting the power during a transaction may cause transaction data files not yet
stored in terminal memory to be lost.
The terminals Li-ion –battery is not hazardous waste. Do not dispose the battery with
combustible wastes. The battery should be recycled with other hazardous wastes or
delivered to the terminal supplier for disposal.

Other manuals for VeriFone Vx520

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VeriFone Vx520 and is the answer not in the manual?

VeriFone Vx520 Specifications

General IconGeneral
Peripheral PortsRS-232, USB
Power Supply100-240 VAC, 50/60 Hz
Operating Temperature0°C to 50°C (32°F to 122°F)
Processor400 MHz ARM11
Memory128 MB Flash
Display128 x 64 pixel LCD with backlight
ConnectivityDial-up, Ethernet
Card ReadersEMV chip
ContactlessOptional
PrinterIntegrated thermal printer
SecurityPCI PTS
SAM Slots3
ComplianceEMV Level 1 & 2, RoHS

Related product manuals