Verizon TCL LINKZONE 5G UW - Data Usage Monitoring; Connected Device Management; Message Viewing

20
WPS
Wi-Fi Protected Setup (WPS) is a wireless network security standard that tries to make
connections between your LINKZONE and wireless devices faster and easier. It enables
compatible devices to connect to a wireless network without entering the password.
If your wireless device is WPS-supported, you can access the LINKZONE Wi-Fi network
through a WPS connection.
To make a WPS connection:
1. Log in to the web UI of your LINKZONE, and go to Wi-Fi > WPS. (For how to log in to
the web UI, see "Chapter 4. Accessing the Admin web" .)
2. Click Start WPS.
3. Enable the WPS function of your wireless device within 2 minutes to make a WPS
connection.
When a WPS connection is established, the WPS icon will show on the upper right corner
of the status bar. If the connection fails to be established, enter the Wi-Fi password
manually.
NOTE: WPS will be disabled if W-Fi security is set to WPA3, Disabled or encryption is
set to AES, or SSID broadcast is turned off.
6.3 Data Usage
This section displays the amount of data used and your monthly billing plan.
6.4 Connected devices
This tab allows you to edit the connected device name, and manage internet access
for connected devices. You can also block or unblock devices from the list of available
devices.
6.5 Messages
This tab allows you to view your messages. Messages can not be sent or forwarded from
the Mobile Hotspot. Use another mobile device to send messages.
Refer to the following table for the description of each folder under the Messages tab.
Messages
Incoming messages are stored in this folder.
NOTE: Inbox messages does not display if the SIM card is not
properly installed.
Refer to the following table for commonly used operations of SMS messages.
Read a message Click the message you want to read.