• Break Key Sequence: This option allows you to configure the key combination that generates a
break condition. The default key sequence is Alt-B.
To configure a DSRIQ-SRL module:
1. Press Ctrl-F8. The Configuration Screen will appear.
2. Select a parameter to change. You can navigate the Configuration Screen using the Up Arrow
and Down Arrow keys.
3. Modify the selected value using the Left Arrow and Right Arrow keys.
4. Repeat steps 2 and 3 to modify additional values.
5. Press Enter to save your changes and exit the Configuration Screen.
-or-
Press >Escape to exit the Configuration Screen without saving the changes.
6.0.3 Creating a DSRIQ-SRL module macro
Pressing the Page Down key when the Terminal Applications menu’s Configuration screen is displayed
will provide access to the Macro Configuration screen. The DSRIQ-SRL module can be configured with up
to ten macros. Each macro can be up to 128 characters in length.
To create a macro:
1. Select the DSRIQ-SRL module you wish to configure and press Ctrl-F8 to activate the Terminal
Applications menu’s Configuration screen.
2. When the Terminal Applications menu appears, press Page Down to view the Macro
Configuration screen. The Macro Configuration screen shows the ten available macros and the
associated key sequences, if any, for each.
3. Use the Up Arrow and Down Arrow keys to scroll to an available macro number and highlight
the listed keystroke sequence. Type the new macro keystroke sequence over the default. Any
combination of Ctrl or Alt and a single key may be used. When you have finished entering the
keystroke sequence that will activate the new macro, press the Down Arrow key.
4. On the line below the macro keystroke sequence you just entered, type the keystroke
sequence that you wish the macro to perform.
5. Repeat steps 3 and 4 to configure additional macros.
6. When finished, press Enter to return to the previous screen.
6.0.4 Using History mode
History mode allows you to examine the contents of the history buffer, which contains the events that
have occurred.
The DSRIQ-SRL module maintains a buffer containing 240 lines minimum, or 10 screens, of output. When
the history buffer is full, it will add new lines at the bottom of the buffer and delete the oldest lines at the
top of the buffer.
Vertiv™ | Vertiv™ Avocent® MergePoint Unity™ Switch for Dell® Installer/User Guide | 59
To Next Page
Loading...
Need help?
General
