NOTE: The Config Key Sequence, On-Line Key Sequence and Clear History Key Sequence used in the
following procedure are the default values. These key combinations can be changed using the
Terminal Applications menu.
To use History mode:
1. Press Ctrl-F9. The mode will display as History.
2. Press one of the following key combinations to perform the indicated action:
• Home: Move to the top of the buffer.
• End: Move to the bottom of the buffer.
• Page Up: Move up one buffer page.
• Page Down: Move down one buffer page.
• Up Arrow: Move up one buffer line.
• Down Arrow: Move down one buffer line.
• Ctrl-F8: Enters Configuration mode. The Configuration screen will appear.
• Ctrl-F9: While in Configuration mode, returns to the previous screen with History mode
enabled.
• Ctrl-F10: While in Configuration mode, returns to the previous screen with On-Line mode
enabled.
• Ctrl-F11: Clears the history buffer. If you choose this option, a warning screen will appear.
Press Enter to delete the history buffer or Escape to cancel the action. The previous
screen will reappear.
3. When finished, press Ctrl-F10 to exit History mode and return to On-Line mode.
6.0.5 DSRIQ-SRL module pinouts
Table B.1 lists the pinouts for the DSRIQ-SRL module.
DB9-F PIN HOST SIGNAL NAME DESCRIPTION SIGNAL FLOW SRL SIGNAL NAME DESCRIPTION
1 DCD - Data Carrier Detect Out of SRL DTR - Data Terminal Ready
2 RXD - Receive Data Out of SRL TXD - Transmit Data
3 TXD - Transmit Data In to SRL RXD - Receive Data
4 DTR - Data Terminal Ready In to SRL DSR - Data Set Ready
5 GND - Signal Ground N/A GND - Signal Ground
6 DSR - Data Set Ready Out of SRL DTR - Data Terminal Ready
7 RTS - Request to Send In to SRL CTS - Clear to Send
8 CTS - Clear to Send Out of SRL RTS - Request to Send
9 N/C - Not Connected N/A N/C - Not Connected
Table 5.1 DSRIQ-SRL Module Pinouts
Vertiv™ | Vertiv™ Avocent® MergePoint Unity™ Switch for Dell® Installer/User Guide | 60
To Next Page
Loading...
