6.2.2 Assemble plenum rear and side panels
NOTE: Grilles can be installed on different sides of the plenum depending on discharge configuration.
Verify grill location and install according to facility-layout plans.
NOTE: Electrical connections and some piping connections are made through the plenum. Plan
accordingly.
1. Apply factory-supplied gasket/insulation tape to plenum panels, Figure 7.7 on the next page:
• Onfront solid panels and onfront and rear grilled panels install the gasketing on the inner edge of the
sides, and along the top and bottom edges.
• Onrear solid panels, install the gasketing onthe inner edge of the sides and along the bottom edge only.
• Onside panels, install the gasketing along the bottom edge.
6 ECFans and Plenums
51
To Next Page