Energy (kWh)
Output power
Load Status Options
Sout (kVA)
Apparent output power
Pout (kW)
Active output power
Power factor
Power factor of output power
Load percent (%)
Percentage of recent power rated to output power
4.2.4 Settings Submenu
The settings screen consists of tabs that list UPS settings for configuration and adjusting parameters
with tabs for:
• Input
• Output
• Battery
• Monitor
• System
• Outlet1
NOTE: Do not change parameter settings or reset to factory defaults when powering-off the UPS.
To modify UPS settings:
1. At the main menu, select the Settings icon, and press Enter.
2. When prompted Enter the Settings password. Use the arrow buttons to increase the digit or
change to the next digit. Press Enter when finished. The default Settings password is 111111 (six
ones).
3. Use the arrow buttons to move the cursor left/right and select a tab. Then press Enter to
navigate the option list for the selected tab.
4. Use the arrow buttons to move the cursor through the options. Press Enter to modify the
selected option. Use the arrow buttons to change the setting. Press Enter to confirm the
selection or ESC to cancel the selection.
5. Press ESC to exit from the option list and return to the tab selection. Press ESC again to return
to the main menu.
NOTE: Parameter settings are password protected, for details see Editing Display and Operation
Settings.
4 Operations
21
Liebert® EDGE Installer/User Guide
To Next Page
Loading...
Need help?
General