4.2.5 Control Screen
The Control screen offers UPS-control options.
To adjust the UPS controls:
1. At the main menu, select the Control icon, and press Enter.
2. Press Enter on the Control tab.
3. Use the arrow buttons to move the cursor through the options. Press Enter on the option to be
modified.
4. Use the the arrow buttons to move through the options. Press Enter to select the option or ESC
to cancel.
5. Press ESC to exit the option list and return to the tab selection Press ESC again to return to
the main menu.
Control Options
Turn on/off
Opens the dialog to change operating modes.
Mute/Unmute audible alarm
Silences or un-silences the audible alarm.
Start/Stop battery manual test
Starts the battery self test manually. If the manual self test is already running, stop the self test.
Clear faults
Clears displayed faults after the issue causing the fault is resolved.
Reset power statistics
Resets the the power statistics.
4.2.6 Log Screen
The Log Screen offers tabs that list the current alarms and the alarm/event history. Table 4.2 on the next
page on the below page, describes the alarm messages you may see in the logs.
To view the logs:
1. At the main menu, select the Log icon, and press Enter.
2. Use the arrow buttons to move the cursor left/right and select a tab, then press Enter to
display the log for the selected tab.
3. Use the arrow buttons to move the cursor though the log.
4. Press ESC to exit the log and return to the tab selection. Press ESC again to return to the main
menu.
4 Operations
29
Liebert® EDGE Installer/User Guide
To Next Page
Loading...
