Vetaphone iPM200-5 - Page 50

iPM 200 generator module
® Vetaphone March 2021 3401201GB
Page 50 of 52
Typical required dyn/cm level for:
PRINTING
: 40 - 42 dyne/cm.
For solvent inks
-
: 46 - 48 dyne/cm.
For water based inks
COATING
: 44 - 54 dyne/cm.
Depending on coating type
LAMINATING
: 46 - 48 dyne/cm.
Solvent adhesives
54 - 56 dyne/cm.
Water based adhesives
Typical values for slip additives (Ole amide & Eruc amide)
0
-
400 PPM
: Low slip
400
-
700 PPM
: Medium slip
700
-
1200 PPM
: High slip
1200
-
2000 PPM
: Extremely high slip