After 20 minutes, remove the soaked parts and
rinse with water
Wash the sterilized parts.Parts to be removed
Installed in situ with reference to 14.3 parts
removed
In addition to / installation process) strictly
follow the requirements of this step.
3. Disinfectant (KAY5,28.4/) with 1 liter of
water and 1/2 packs
Package), with disinfectant.
4. plug in the power plug, then press "
"key to make the ice maker in standby
state, the screen shows "OFF"; press
" key, the ice maker enters the
cleaning stage, the inlet valve opens, the
screen display starts to time, when the
evaporator begins to flow water, add the
equipped disinfectant to the ice maker
sink, and at the same time, use the outer
surface of the spray with disinfectant
The water
between the tank and the evaporator
has been cleaned in circulation for about
15 minutes. After that, the cleaning stops,
drainage begins and the evaporator is
flushed
30 s after completion of drainage;
5. Enter the automatic rinsing phase, clean
for 3 minutes,
After another 30 s, of water rinsing,
Rinse again with purified water for 3
times, the whole cleaning process
At the end, the screen shows "OFF", for
about 37 minutes
After the cleaning process is over, the
screen displays "OFF", to enter
Machine status, then unplug;
6. Note: start making ice after cleaning and
disinfection
The ice is discarded and not eaten.
14.3 Removal/installation process of parts
a．When removing the pipe, remove "pull out"
clamps "and" upper pipes "(as shown):
Pull out the hose
To Next Page
Loading...
