VEVOR LB210A - Power Connection and Pre-Operation Checks; Power Supply Requirements and Safety; Initial Cleaning and Installation Inspection

Safety Tips
Number: JT190199990 Version Number: A1
Note: Subsequent versions of this specification are subject to change without prior notice. Thank you
6/23
Power supply
7. Power supply
 The voltage, frequency and capacity of
the power supply shall be consistent with
the nameplate of the machine.
 ±10% fluctuation of rated power voltage
is allowed.

Separate circuit breakers must be
installed for the ice maker..
Warning
The power supply must be reliably
grounded, and the wiring must conform to
the national and regional laws and
regulations of the ice maker.
8. Clean after Installation
After the ice maker is installed, clean the shell,
liner and ice scoop with a clean wet cloth or
sponge;
Warning
Banana water, oxalic acid, hydrochloric a
cid, alcoholic liquids and other corrosive det
ergents are strictly prohibited.
9.
Check after Installation
After the ice maker is installed, check
against the following information before
operation.
 Is ice maker placed levelly？
 Have you removed all the transportation
seals？
 Are all the water and electricity connected
well？

Is the supply voltage consistent with the
rated voltage on the nameplate?
 Is the ice maker properly grounded?
 Are there adequate air Spaces around
the ice maker?
 Is the ambient temperature of the ice
maker between 10°C and 38°C?

Does the water inlet temperature remain
between 5°C and 32°C?
Are the ice maker and refrigerator cleaned？