Important safety information
Please observe the following safety precautions when using your OSSC Pro.
Use the correct power supply – OSSC Pro is designed to run with a 5 volt, 2.1 x 5.5mm positive
tip power supply unit (PSU) supplying at least 2.5 amps of current. Please ensure your power
supply meets these requirements. Never connect a power supply that supplies more than 5 volts.
Doing so can damage the OSSC.
Turn off the power before connecting/disconnecting equipment – To prevent damage of the
OSSCs integrated circuits, always turn off the power before connecting to a display or a device.
Do not expose to moisture – Droplets of moisture may contact the PCB and cause a short circuit.
Never submerge the unit in water.
Keep away from fire or high heat sources – OSSC is not flammable but high temperatures, such
as those from a fire or electric heater may melt the plastic casing.
Please supervise children – This product is not a toy and is not designed for use by children.
Please supervise children if they use the OSSC Pro.
Beware of using the bob deinterlace mode on sources that display static graphics or text for a
long period of time – This deinterlacing mode produces a constant flickering effect. This can cause
image retention/burn-in to occur faster than normal. Usually this applies to LCD TVs/monitors only,
CRT displays are not adversely affected by this mode. We recommend using the scaler mode and
motion adaptive deinterlacing where possible, see page 15 for more details.
To Next Page
Loading...
