Parking the machine
41
Machine without hy-
draulic cylinder
The machine must be parked in transport position.
> Remove the spring clip, lower the jack stand fully and mount the
spring clip
> Use the 3-point hitch to lower the machine fully
> Place the pto drive shaft on the support provided
> Unhitch the machine
Machine with hydrau-
lic cylinder [+]
The machine must be parked in transport position, with the mowing
unit fully lowered.
> Open the valve at the hydraulic cylinder
> Lower the mower unit horizontally using the hydraulic cylinder
The hydraulic cylinder must be fully extended.
> Place the hydraulic lever in floating position
> Close the valve at the hydraulic cylinder
This in order to avoid hydraulic oil leaking from the hydraulic cylinder.
> Remove the spring clip, lower the jack stand fully and mount the
spring clip
> Use the 3-point hitch to lower the machine fully
> Disconnect the hydraulic connection and store the hydraulic hose
at the provided support to ensure coupling plugs stay clean
> Place the pto drive shaft on the support provided
> Unhitch the machine
Cleaning of drum
skirts/skid discs
After every working day:
> clean the space between drum skirts and skid discs
E0412
Spring
clip
Support
jack
E0412
Spring
clip
Support
jack
To Next Page
Loading...
